8
16. Press the
Purge
tab on the far left side of the screen.
17. Scroll down to the water modules and press the
Purge
buttons for both the plain water and the carbonated water
modules.
Once the purge is activated, it will continue to dispense
product until it is deactivated. To deactivate the purge,
simply press the
Purge
button again. Up to four
modules can be purged at one time. Once four modules
are selected, all other modules are greyed out and
cannot be selected.
NOTE
18.
Once a steady flow of water is achieved, press the
Purge
button again to deactivate the modules.
19.
Repeat steps 10 - 18 for the second screen.
20. Make sure the pump deck is turned OFF before turning on
CO
2
.
21. Turn on CO
2
at the source then, using a screwdriver, adjust
the high pressure regulator at the source to 110 psi (0.758
MPa) then tighten locknut with wrench.
A. Regulator Adjustment Screw
B. Adjust to 110 psi (0.758 MPa)
C. Wrench
A
B
C
The pump deck has a 3 minute timeout feature. If the
timeout occurs, turn the deck OFF then ON by flipping
the switch on the control box.
NOTE
To check for CO
2
leaks, close the valve on the CO
2
cylinder and observe if the pressure to the system
drops with the cylinder valve closed for five minutes.
Open the cylinder valve after check.
NOTE
26. Activate each valve to purge air from the syrup lines.
22. Adjust both of the low pressure regulators on the regulator
manifold to 75 psi (0.517 MPa) then tighten locknut with
wrench.
23.
Activate each valve until gas-out.
24. Plug in the remote carbonator pump deck, if not already
done so, and turn the switch to the ON position.
25. Activate each valve until the carbonator pump comes on.
Release the button, allow carbonator to fill and stop. Repeat
this process until a steady flow of carbonated water is
achieved.
Adding New Brand/Flavor Modules
1.
In order to add a new brand or flavor module, the module
must first be activated.
2. From the Service menu, press the
Valve Configuration
button.
5. Select a new brand from the available Brands Library tabs
on the left side of the screen.
3.
From the Valve Configuration menu, press the
Configure
tab
on the far left side of the screen.
4. Press the
Configure
button under any brand or flavor
module to open its Configuration Page.
