4
If installing a Scotsman
®
icemaker, Lancer recommends
setting the auto agitation time to every 60 minutes. To
adjust the agitation time, set the dip switches located in
the control box behind the merchandiser. See the DIP
Switch Legend diagram on page 19 of this manual for
reference.
NOTE
5. Ensure the icemaker is installed properly to allow for removal
of the Merchandiser.
6.
Ensure manual fill is accessible.
7. Clean and maintain icemaker per manufacturer’s
instructions.
Failure to use an ice bin thermostat will not only void
your IBD’s warranty but will result in the inability to
control the level of ice in the ice bin which can cause
damage to your dispenser.
!
ATTENTION
1.
To remove the merchandiser, first detach the left and right
side from the connection tabs behind the merchandiser, by
pulling away from the unit.
The installation, and relocation if necessary, must
be carried out by qualified personnel with up-to-date
knowledge and practical experience, in accordance
with current regulations.
NOTE
3. Twist/Rotate the ADA panel, located on the unit’s splash
plate, in a counterclockwise direction up to a 45° angle.
4. Carefully pull ADA panel and electric wire harness from the
unit’s splash plate, until the harness connector is visible.
5. Disconnect ADA harness and remove from the unit. Repeat
Steps 3-4 for second ADA panel.
6. Remove the splash plate and drip tray.
7. Route appropriate tubing from the water source to the water
inlet at the remote pump deck.
8.
If necessary, install water booster (Lancer PN MC-163172)
between water supply and the remote pump deck.
9.
Using tubing cutters, cut the water line and install U-fitting
then route appropriate tubing from the U-fitting to the plain
water inlet at the unit.
A
B
A. Merchandiser
B. Splash Plate
A
B
C
A. Line to Water Source
B. U-Fitting
C. Line to Remote Pump Deck
D. Line to Plain Water Inlet
D
A
A. Remote Pump Deck
B. Pump Inlet
C. Pump Outlet
D. Line to Carb Inlet
B
C
D
10. Route appropriate tubing from the remote pump deck outlet
to the carbonated water inlet at unit.
Dispenser Installation
2. Rotate the merchandiser, away from the unit, from the
bottom then lift the merchandiser straight up to detach from
the top of the ice bin and remove from the unit.
11.
Install a shut-off valve in the water line feeding the remote
pump deck as well as the water line feeding the plain water
inlet.
