17
Cleaning & Sanitizing Flavor Injector Lines
1.
Disconnect the each flavor injector line from their bag-in-box
containers.
2.
Place flavor injector lines, with BIB connectors, in a bucket of
warm water.
3.
Activate each flavor injector line to fill the with warm water
and flush out any syrup remaining in the lines.
4. Prepare Cleaning Solution described on page 14.
5.
Place flavor injector lines, with BIB connectors, into
cleaning solution.
6.
Activate each flavor injector line until lines are filled with
cleaning solution then let stand for ten (10) minutes.
Following sanitation, rinse with end-use product until
there is no aftertaste. Do not use a fresh water rinse.
This is a NSF requirement. Residual sanitizing solution
left in the system creates a health hazard.
!
CAUTION
7.
Flush out cleaning solution from the flavor injector lines using
clean, warm water.
8. Prepare Sanitizing Solution described on page 14.
9.
Place flavor lines into sanitizing solution and activate each
line to fill with sanitizer. Let sit for ten (10) minutes.
10.
Reconnect syrup lines to bag-in-box container and draw
drinks to flush solution from the dispenser.
11.
Taste the drink to verify that there is no off-taste. If off-taste
is found, flush syrup system again.
PLUMBING DIAGRAM
FS44 Sensation Unit Plumbing Diagram
To prevent possible harm to the environment from improper disposal, recycle the unit
by locating an authorized recycler or contact the retailer where the product was
purchased. Comply with local regulations regarding disposal of the refrigerant and
insulation.
Dispenser Disposal
