background image

2

•  WARNING:

 Carbon Dioxide (CO2) is a colorless, noncombustible gas with a light pungent odor. High percentages of CO

2

 may 

displace oxygen in the blood. 

•  WARNING: 

Prolonged exposure to CO

2

 can be harmful. Personnel exposed to high concentrations of CO

2

 gas will experience 

tremors which are followed by a loss of consciousness and suffocation. 

•  WARNING: 

If a CO

2

 gas leak is suspected, immediately ventilate the contaminated area before attempting to repair the leak. 

•  WARNING: 

Strict attention must be observed in the prevention of CO

2

 gas leaks in the entire CO

2

 and soft drink system.

Carbon Dioxide (CO

2

)

Provide an adequate potable water supply. Water pipe connections and fixtures directly connected to a potable water supply must 

be sized, installed, and maintained according to federal, state, and local laws. The water supply line must be at least a 3/8 inches 

(9.525 mm) pipe with a minimum of 25 PSI (0.172 MPA) line pressure, but not exceeding a maximum of 50 PSI (0.345 MPA).  

Water pressure exceeding 50 PSI (0.345 MPA) must be reduced to 50 PSI (0.345 MPA) with the provided pressure regulator. Use 

a filter in the water line to avoid equipment damage and beverage off-taste. Check the water filter periodically, as required by local 

conditions. The water supply must be protected by means of an air gap, a backflow prevention device or another approved method 

to comply with NSF standards. A leaking inlet water check valve will allow carbonated water to flow back through the pump when it 

is shut off and contaminate the water supply. Ensure the backflow prevention device complies with ASSE and local 

standards. It is the responsibility of the installer to ensure compliance.

Water Notice

Units are equipped with an automatic agitation system and will activate unexpectedly. Do not place hands or foreign objects in the 

ice bin. Unplug the dispenser during servicing, cleaning, and sanitizing. To avoid personal injury, do not attempt to lift the dispenser 

without assistance. For heavier dispensers, use a mechanical lift.

Automatic Agitation

SPECIFICATIONS & FEATURES

DIMENSIONS

 

Width

: 22.0 inches (599 mm)

 

Depth

: 31.0 inches (787 mm)

 

Height

: 35.5 inches (902 mm)

WEIGHT

 

Shipping

: 292 lbs (132 kg)

 

Empty (w/out ice)

: 270 lbs (122 kg)

 

Ice Capacity

: 150 lbs (68 kg)

CARBON DIOXIDE (CO

2

) SUPPLY

 

Min Pressure

: 70 PSIG (0.483 MPA)

 

Max Pressure

: 80 PSIG (0.552 MPA)

FITTINGS

 

Carbonator Inlet

: 3/8 inch barb

 

Plain Water Inlet

: 3/8 inch barb

 

Brand Syrup Inlets

: 3/8 inch barb

 

CO

2

 Inlet

: 3/8 inch barb

ELECTRICAL

 

115 VAC / 60 Hz / 3.0 Amps

PLAIN WATER SUPPLY

 

Min Flowing Pressure

: 25 PSI (0.172 MPA)

CARBONATED WATER SUPPLY

 

Min Flowing Pressure

: 25 PSI (0.172 MPA)

 

Max Static Pressure

: 50 PSI (0.345 MPA)

This unit emits a sound pressure level below 70 dB

Bevariety™ ACIB 22”

DIMENSIONS

 

Width

: 30.0 inches (762 mm)

 

Depth

: 31.0 inches (787 mm)

 

Height

: 35.5 inches (902 mm)

WEIGHT

 

Shipping

: 356 lbs (161 kg)

 

Empty (w/out ice)

: 327 lbs (148 kg)

 

Ice Capacity

: 250 lbs (113.6 kg)

CARBON DIOXIDE (CO

2

) SUPPLY

 

Min Pressure

: 70 PSIG (0.483 MPA)

 

Max Pressure

: 80 PSIG (0.552 MPA)

FITTINGS

 

Carbonator Inlet

: 3/8 inch barb

 

Plain Water Inlet

: 3/8 inch barb

 

Brand Syrup Inlets

: 3/8 inch barb

 

CO

2

 Inlet

: 3/8 inch barb

ELECTRICAL

 

115 VAC / 60 Hz / 3.0 Amps

PLAIN WATER SUPPLY

 

Min Flowing Pressure

: 25 PSI (0.172 MPA)

CARBONATED WATER SUPPLY

 

Min Flowing Pressure

: 25 PSI (0.172 MPA)

 

Max Static Pressure

: 50 PSI (0.345 MPA)

This unit emits a sound pressure level below 70 dB

Bevariety™ ACIB 30”

Summary of Contents for Bevariety ACIB Series

















Reviews: