HoW tHe VaPor FIre eLeCtronIC
DraFt ControL WorkS
reaD OVer the FOllOwing
explanatiOns Very CareFully
1. When you first turn on the power – the 24 volt
electronic control is energized, the controls high
temperature siren sounds for only a short time,
then after this, the control will automatically go to
the low temperature setting which is when only
the GREEN LIGHT is on.
2. When first starting a fire, you may open the ash
pan door for a very short while until the control
senses the heat which is being generated by the
fire. Once the control senses the heat it will au-
tomatically open the draft shutter. (ALL THREE
LIGHTS WILL THEN BE ON). Allow the ash pan
door to remain open for a short period of time to
assure that the wood has properly ignited. NOW
ClOse the ash pan DOOr anD the eleC-
TRONIC CONTROL WILL TAKE OVER AND IT
will COntrOl the DraFt as neeDeD tO
BURN THE WOOD, MAKE SURE THE ASH
pan DOOr remains ClOseD anD that the
LATCH IS HOOKED THROUGHOUT THE EN-
tire burn.
*** neVer eVer Burn tHe StoVe WItH tHe
aSH Pan Door oPen otHer tHen DurInG
tHe FIrSt FeW MInuteS WHen StartInG
tHe FIre.
3. The electronic control has four different stages
and the lights on the control indicate how much
air is entering the fire chamber, for example as
follows:
A. At start up, all three lights are on and
also again at the end of the burn cycle, this indi-
cates that the shutter is wide open.
B. As the fire gradually intensifies, only two
lights are on which means that the control has
automatically decreased the amount of air going
into the fire chamber, now the shutter is partially
closed.
C. As the temperature in the fire chamber con-
tinues to rise, the control automatically closes so
that only One light is on which means that the
shutter is almost close.
D. When the temperature in the fire chamber
has reached it’s optimum level, there will be
nO lights On. Now the shutter is completely
closed, the stove is now what we call on the pilot
burn and will continue like this until the fire cham-
ber cools down and then the control again takes
over and will adjust the shutter opening based on
the fire chamber temperature.
4. The LOW TO HIGH TEMPERATURE KNOB is
used to adjust the total heat output of the vapor
fire furnace, depending on what the temperature
is outside.
Hot
CoLD
H
o
t
C
o
L
D
S
t
o
P
For PoWer outaGe
oPen ManuaLLy
8” BaCk DaMPer
oIL
or
GaS
or
eLeCtrIC
VF
200
This is just the basic idea to tie the two
systems together. The cold air side back
flow flap may or may not be needed.
BOX 422 • TOWER, MN 55790 • USA • Tel (218) 753-2330 • www.lamppakuuma.com
18
H
o
t
465 CFM
CoLD aIr
FroM
uPStaIrS
BaCk
FLoW
FLaP
StoP
