iXinox 24 C
41
EN
cod. 3541N452EN - Rev. 03 - 03/2020
Cleaning or replacing the flowmeter
A
Before carrying out the following instructions it is advisable to protect the room and the boiler’s electrical box
against accidental water spillage.
•Disconnect the power supply and turn off the gas cock ahead of the valve.
•Remove the diverter valve connector
•Close the cold water inlet and turn on the DHW system faucets
•Release the fork
“4”
and remove the flowmeter assembly
“5”
.
•The flowmeter components can thus be cleaned (see fig. 49 and fig. 50) or replaced.
fig. 48- Flowmeter
1
- Flow-rate restrictor
2
- Fan
3
- Filter
4
- Clip
5
- Flowmeter
Wash the filter with clean water.
fig. 49
Lubricate the flowmeter gaskets with silicone grease.
fig. 50
5
4
1
2
3
