Laguna Tools MCNC Creator Pro I-24P, Manual

Page: 52 / 66

MCNC Creator Pro I-24P
52
Symptom Possible Cause Correction
Router cutting depth
inconsistent.
Loose cutter Tighten cutter in spindle collet.
Spoil boards not flat. Check that spoil boards are flat
and clean prior to fitting job.
Excessive play in Z-axis
ballscrew.
Inspect and correct if needed.
Machine won’t power on.
E-stop switch engaged. Release E-stop switch.
No incoming power. Check power plug connection.
Check condition of power cable.
Faulty start switch. Inspect and replace.
Internal breaker faulty. Replace breaker.
Machine will not home.
Limit switches damaged,
disconnected, or misadjusted.
Inspect limit switches and
correct problem.
9.2 Controller Functions Problems
Symptom Possible Cause Correction
WARNING
Some connections may require a qualified electrician.
Controller display is blank or
flickering.
Cable connections not tight. Inspect and tighten connections
between pendant and control
box.
Loose 24V connection to control
board.
Check the 24V connection to the
DSP board in the control box.
Interface damaged. Replace damaged part.
Controller damaged. Replace controller.