Laguna Tools MCNC Creator Pro I-24P, Manual

Page: 21 / 66

MCNC Creator Pro I-24P
21
4.0 Operations
Before beginning, Laguna Tools recommends that the operator become familiar with the
handheld controller for operation of the machine, setting up a job, and processing a file.
4.1 Controller
Toolpaths that are created in the design software are
communicated to the CNC router through the handheld
controller. In the case of the Creator Pro series machines, this
is done through the RichAuto B18E controller.
Processing toolpaths or jobs is performed either by using a
USB flash drive (USB 2.0 of 8GB or smaller) or from internal
memory.
Internal memory is recommended for jobs of one (1) hour run
time or longer and any files that will be used frequently.
The RichAuto B18E keypad, which is seen here, is either.
Single touch functions where buttons may perform once of
many single tasks or if held down, will perform a task
continuously (such as machine movement).
Combination functions, where two (2) keys are pressed at the
same time.
4.2 Operating Procedure
Machine operation may be done several ways; either through the controller keypad or through the
design files (toolpaths) which can be downloaded to the controller through the USB (U-Disk) or
ran from internal memory.
Before performing an operation
1. Verify the machine stand leveling feet (if available) have been lowered to prevent the
machine from moving.
2. Ensure that the workpiece is securely held to the table which can be done using any of the
following:
Figure 4-1: B18E Handheld
Controller