MCNC Creator Pro I-24P
16
b. Insert the toolbox into the stand from the top. The hangers will fit snugly between the
braces on either side of the toolbox.
c. The front can be slid forward to rest within the opening on the stand upright.
6. Install the hook on the front righthand side of the stand using the included hardware.
2.6 Installing the Router Table on the Stand
The Creator Pro CNC router table assembly is heavy. Please use a safe, secure method for lifting
and use caution when placing the machine.
To avoid damage, be careful to never lift the router by the gantry.
1. If using a forklift, keep forks under the steel frame to avoid damaging the wiring and
mechanics of the machine. Place a scrap piece of lumber beneath the router assembly and
carefully slide forks beneath the steel base. Verify the forks extend through to the other side
of the machine for safe lifting.
2. Position router over the stand and align holes on router mounting flanges and stand uprights.
Being careful to make sure the stand is properly oriented with the machine front.
3. Place one (1) rubber bushing over each of the holes in the stand. Lower the machine to sit on
the bushings.
a. Attach the machine to the stand using one (1) M10 hex bolt, one (1) washer at each
corner.
b. Insert the bolt/washer through the machine
mounting flange and the rubber bushings
c. Thread the bolt loosely into the stand
mounting holes. Do not tighten until all bolts
have been threaded.
d. Remove the forklift and tighten bolts evenly.
4. Place a level on the router table, then level the
assembled machine by adjusting the leveling feet.
Level the machine in all directions.
2.7 Finishing Machine Assembly
With the machine mounted on the stand or safely on a secure work surface, finish the setup.
Figure 2-4: Rubber Bushing
Summary of Contents for MCNC Creator Pro I-24P
