Laguna Tools MCNC Creator Pro I-24P, Manual

Page: 49 / 66

MCNC Creator Pro I-24P
49
8.0 Maintenance
To ensure proper machine operation, it is recommended that the prismatic guides and rolled
ballscrews on all axes are kept clean regularly wiped down with a light machine oil lubricant (such
as 3-IN-ONE oil).
8.1 Routine Checks (performed daily with machine use)
1. Wipe the ballscrews and prismatic guides clean and dust free.
2. Apply light machine oil to ballscrews and prismatic guides using a clean cloth. Move the
machine through travel limits to properly disperse lubricant.
3. Check cutting tool edges for chips and/or dullness.
4. Generally, inspect the machine for any damage.
5. Ensure that slots in the collets are free of sawdust and debris.
6. Check coolant levels in reservoir.
7. Verify that the dust extractor is free of blockages.
8. Check that all electrical connectors are fitted correctly and are not loose.
8.2 Cooling System Flush/Refill
On Creator Pro series machines, every 4-6 months the electro spindle cooling system should be
flushed and refilled to guarantee that the coolant is fresh and bale to perform optimally.
The cooling system consists of a clear reservoir/pump assembly.
To flush the system, it is recommended that users acquire:
1. A small (12-inch) section of 5mm tubing.
2. Empty the container used to catch old fluid.
3. Container of distilled water (Flush).
4. Fresh Propylene Glycol (RV/Marine Grade) coolant.
First, locate the cooling system which can be found on the rear side of the gantry. Uncover the
cooling system by removing the three (3) screws which hold the black cover in place.
Once the cover is removed, notice the cooling pump/reservoir, as seen here: