13
Product Service Domestic 1-800-522-7658, International 816-333-8811
Chapter 3: Getting Started
If you do not receive one or more of the components
listed for your CentriVap, or if any of the components
are damaged, contact Labconco Corporation
immediately for further instructions.
Setting Up Your CentriVap
After you verify receipt of the proper components,
move your CentriVap to the level and sturdy location
where you want to install it. There is no need to secure
the CentriVap to the work surface. Then, follow the
steps listed below.
Emergency Access Into the
Chamber
The CentriVap is designed to prevent access to the
chamber in the event of a power disruption. If it is
necessary to open the lid when there is no electrical
power connected to the CentriVap, insert a small
screwdriver or similar instrument into the small round
hole on the left side of the case near the top behind the
control panel. This will unlock the lid latch
mechanism. While holding the screwdriver in place,
raise the lid with the other hand.
Never attempt to defeat the latch or
open the lid while the CentriVap is
running.
Component Orientation & Hose
Connections
The relative position of the CentriVap Concentrator,
Cold Trap and the vacuum pump may be as shown or
may be reversed. The refrigeration system in the Cold
Trap exhausts air through the rear of the cabinet. A
minimum of 3" should be allowed between the back of
the Cold Trap and the adjacent wall surface and
between the sides of the Cold Trap and the adjacent
!
