Lab-Volt Tech-Design eSeries, Manual

Page: 13 / 53

Activity Guide
Tech-Design by Lab-Volt
5
Controls & Sensors The fischertechnik Control System
Selection and Start of a Program in the Flash Memory
Press and hold pushbutton #4. The green LED beside the button indicates the selected program 1.
(1 or 2, continuously illuminated indicator lights). When the desired program has been selected,
release the pushbutton.
To start the program, press button #4 again. As long as the program is running, the LED blinks.
2.
To end the program, press button #4 again. The LED is then continuously illuminated. 3.
Selection and Start of a Program that is in RAM
Press and hold pushbutton #4 down until both green LEDs beside the button are illuminated at the 1.
same time. Then release the button. Both LEDs are illuminated only if a program is in the RAM.
To start the program, press pushbutton #4 again. As long as the program is running, both LEDs
2.
blink.
To end the program, press pushbutton #4 again. The LEDs are then continuously illuminated.
3.