English
Description
Firenze - Italia
Display
Operating Procedure
19
www.lamarzocco.com
Version 1.3
GB/5 - FB/80
Factory Level Parameters
Cup Heating Time Settings
•
The cup heater is an optional feature that adds a
resistance type heating capacity to the espresso
machine cup storage area.
•
If installed, the cup heater turns on and off for during
a programmed cycle time.
•
This parameter has three settings.
•
The first setting is “Cup heating on”. This is a time, in
minutes, that the cup heater is turned on during a
cycle.
•
The second setting is “Cup heating off”. This is a
time, in minutes, that the cup heater is turned off
during a cycle.
•
The third setting is “Cup Heating Initialization (Int.)”.
This is a time interval, in minutes, that the cup heater
will delay when the espresso machine is turned on.
This feature is provided to reduce the amount of
power required when the espresso machine is
heating the water in the boilers.
•
This parameter is set at the factory and should not be
changed.
Password
?????
Press and hold the
button on the group 1 keypad until the following is displayed
(approximately 10 seconds):
1
LaMarzocco 09:30
Enter the 5 digit factory password using buttons 1-5 on the group 1 keypad. Once accepted the
following appears:
2
Groups Number
3
3
Press the
button on the group 1 keypad until the following appears (abouteleven times):
MODE
Cup heating
Times
When finished, continue to the next parameter or press
to exit programming mode.
7
ON
OFF
Press the
or the
button to change the setting of the flashing value. When the desired
value is displayed press
to confirm and advance to the next value.
5
+
ENTER
Cup heating
Times
Press the
button on the group 1 keypad to access the settings for this parameter.
4
ENTER
Repeat procedure 5 for the remaining two values.
6
Cup heating on
3 min
Cup heating Off
3 min
Cup heating Ini
30 min
Software Programming Manual - ENG - V 1.3.pmd
30/10/2006, 14.39
19
