COMPONENT MAINTENANCE MANUAL
AVIATION RECORDERS
FA2100CVR
Rev. 15 Page 178
Apr. 14/16
Testing & Fault Isolation
23–70–04
Use or disclosure of information on this sheet is subject
to the restrictions on the cover page of this document.
10. FA2100CVR SOFTWARE UPLOAD PROCEDURE
Computer Interface Communications Cable/2 (CICC/2) is shown in Figure 177. In the
event that the original Acquisition Processor (AP) PWA, p/n: 205E1591
−
00 or
205E1931
−
00, is required to be replaced in the FA2100CVR, it will be replaced with the
Acquisition Processor PWA, p/n 205E2502
−
11, or
−
14 in the case of the 2100
−
1025
−
( ),
and the software that is required to be loaded onto this PWA. To load the software, use
the FA2100 Software Upload cable assembly, p/n: 17TES0058 and the FA2100 Software
Upload Utility software. The Upload Utility software contains a CICCLDR executable file
and a CICCIFC executable file. The CICCLDR and CICCIFC executable files are found
on the FA2100 Utility Bundle CD p/n 883E1894
−
01.
NOTE:
The CICC/3 with ethernet (P/N 17TES0075) cannot be used to
upload FA2100CVR software.
The Software Upload cable assembly is connected between the front panel GSE connec-
tor of the FA2100 and the CICC/2 Cable assembly, which includes the Computer Interface
Communications Cable/2 (p/n: 17TES0070) and the FA2100 to CICC/2 cable (p/n:
17TES0072).
The software upload procedure is also necessary when replacing a faulty Turbo Acquisi-
tion Processor PWA, p/n: 205E2502
−
10/
−
11 with a known good AP board from the facto-
ry, since the factory spare PWA’s are shipped without the recorder firmware preloaded.
The specific recorder software for either the 2100-1010-( ) 2100-1020-( ) or the
2100
−
1025
−
( ) CVRs will be loaded from the FA2100CVR Software Distribution CD.
Once installed, a Windows-98/XP short-cut icon linking to the CICCLDR.exe may be
placed on the desktop. To upload the recorder software perform the following procedure:
NOTE:
After installing CICC loader and/or interface on Windows 7, you
must set the properties of CiccLDR.exe and/or the Ciccldr.exe to
run in compatibility mode of “Windows 98/Windows Me.”
A.
Installing Software Upload Utility and CICC Interface Programs
NOTE:
The Software Upload Utility and the CICC Interface Pro-
grams may be loaded onto a ROC/5, ROC/6, ROC/7, RAU, or
any PC. Reference to any of these units is herein referred to
as PC.
The Software Upload utility and Interface executable programs are contained on the
CICC Utility Bundle CD. To load these programs onto a PC perform the following
steps:
The document reference is online, please check the correspondence between the online documentation and the printed version.
