Foreman Ductable Dual Fuel Indirect-Fired Heater
www.lbwhite.com
Owner’s Manual • Foreman
10
General Installation Instructions
INSTALLATION INSTRUCTIONS
WARNING
Fire and Explosion Hazard
Can cause property damage, severe injury or death.
To avoid dangerous accumulation of fuel gas, turn off
gas supply at the heater service valve before starting
installation, and perform gas leak test after comple-
tion of installation.
1. Read all safety precautions and follow L. B. White
recommendations when installing this heater. If
during the installation or relocating of heater, you
suspect that a part is damaged or defective, call a
quali
fi
ed service agency for repair or replacement.
2. Using a level, make sure the heater is level and
properly positioned before use. Observe and obey
all minimum safe distances of the heater to the
nearest combustible materials. Safe distances are
given on the heater dataplate and speci
fi
cations on
page 4 of this manual.
3. This heater may be installed either indoors or
outdoors. For indoor installations, the heater must
be vented to the outside. See installation of inside
structure section of this manual.
4. The heater’s gas pressure regulator (with pressure
relief valve) must be protected from adverse
weather conditions (rain, ice, snow) as well as
from building materials (tar, concrete, plaster, etc.)
which can affect safe operation and could result in
property damage or injury.
5. Heaters used in the vicinity of combustible tar-
paulins, canvas, plastics, wind barriers, or similar
coverings shall be located at least 10 feet/3.05
meters from the coverings. The coverings shall be
securely fastened to prevent ignition or upsetting
of the heater due to wind action on the covering or
other material.
6. Check all connections for gas leaks using ap-
proved gas leak detectors. Gas leak testing is
performed as follows:
-- Check all pipe connections, hose connections,
fi
t-
tings and adapters upstream of the gas control with
approved gas leak detectors.
-- In the event a gas leak is detected, check the
components involved for cleanliness and proper
application of pipe compound before further tight-
ening.
-- Tighten the gas connections as necessary to stop
the leak.
-- After all connections are checked and any leaks are
stopped, turn on the main burner.
-- Stand clear while the main burner ignites to prevent
injury caused from hidden leaks that could cause
fl
ashback.
-- With the main burner in operation, check all
connections, hose connections,
fi
ttings and joints
as well as the gas control valve inlet and outlet con-
nections with approved gas leak detectors.
-- If a leak is detected, check the components
involved for cleanliness in the thread areas and
proper application of pipe compound before further
tightening.
-- Tighten the gas connection as necessary to stop
the leak.
-- If necessary, replace the parts or components
involved if the leak cannot be stopped.
-- Ensure all gas leaks have been identi
fi
ed and
repaired before proceeding.
WARNING
Fire and Explosion Hazard
■
Do not use open
fl
ame (matches, torches,
candles, etc.) in checking for gas leaks.
■
Use only approved leak detectors.
■
Failure to follow this warning can lead to
fi
res
or explosions.
■
Fires or explosions can lead to property dam-
age, personal injury or loss of life.
Summary of Contents for Foreman CI500
Page 37: ...Foreman Ductable Dual Fuel Indirect Fired Heater Owner s Manual Foreman 37 Notes ...
Page 84: ......
Page 127: ......