Assembly Instructions, Mounting Instructions and User Instructions
Document Version
HTR-VSA02-3.2
NOTE
The products featured in the diagrams have been used for graphical representation only. Actual products may vary in relation to the diagrams.
Due to the fact that Bathroom Butler is always actively researching new methods and/or materials with a view to further improving its products,
you may notice some differences between the parts you received and the assembly method described herein. Please understand that this
instruction leaflet is intended as a guide only.
PRODUCT GUARANTEE
Please see separate product guarantee card supplied with your HTR for guarantee terms and conditions or visit www.bathroombutler.com.
WARNING
(States a hazard which may pose serious injury or death if exact installation instructions are not followed)
1. DO NOT install the heated towel rail (HTR) in the immediate vicinity of a water outlet, such as a tap or shower.
2. DO NOT attempt to disassemble the HTR, as the warranty will be void if disassembled.
3.
DO NOT damage or tamper with the power cable. If the power cable is damaged please return to place of purchase.
4.
DO NOT use the HTR as a ladder, hang or climb on it, to be used for intended purpose only.
5. The electrical connection must be connected by a registered electrician/wireman in accordance to the relevant wiring codes.
6.
This is a heating device and should be treated as such, and thus precautions should always be followed to reduce the risk of fire, electrical
shock and injury to persons, including but not limited to the following:
6.1. Use the HTR as described in this manual only, any other use not recommended by the manufacturer may cause fire, electric shock or
personal injury.
6.2. Use the HTR for drying towels and adding some warmth to towels.
6.3. Due to high temperature and the risk of fire, keep electrical cords, drapery, furnishing and other combustibles at least 900mm / 3 ft /
36 inches clear from the front of the HTR.
7. The PTSelect Switch and TDC Timer are NOT electrical isolators.
8. To provide continued protection against risk of electric shock, this product must be EARTHED and connected to an EARTH LEAKAGE
protected circuit.
9. Before attempting any maintenance of the HTR ensure that the power is disconnected (switched off) at the point of isolation.
10. Check product rating label voltage and make sure correct voltage is supplied at electrical point.
CAUTION
(States a hazard which may pose minor injury and/or product damage if installation instructions are not followed)
1.
HOT Surfaces, avoid contact with bare skin.
2. The heated towel rail (HTR) is intended for indoor use only.
3. The temperature of the individual rails of the HTR will increase when covered, AVOID touching the covered rails as the increase in rail
temperature may cause a minor contact burn.
4.
Discoloration of certain bath towels may occur due to fabric make up, detergent residue or excessive amount of towels placed on HTR.
Reduce the temperature accordingly using the PTSelect Switch or TDC Timer (whichever is applicable).
5.
Piling multiple towels on top of each other increases the risk of towel discoloration due to heat.
6. DO NOT place this appliance inside a shower, sauna, steam room or wherever the product would be exposed to direct constant water jets.
7.
DO NOT clean while the HTR is hot.
8. DO NOT clean with an abrasive or acid based cleaning material (such as a tile grout remover/cleaner). Use only a soft, damp cloth.
9. The wall fasteners provided with the installation kit are for convenience purpose only, and are not suitable for all types of installations.
It is the ultimate responsibility of the installer to ensure that the appliance is mounted securely.
10. This HTR is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental
capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with the HTR and hurt
themselves in any way.
11.
If the HTR is not in use for an extended period of time, it is recommended to disconnect (switch off) the power at the point of isolation.
12. When handling the HTR during installation be careful not to scratch, damage or dent any surfaces as this is not covered by the warranty.
Thank you for purchasing this product.
Please read these instructions carefully before installing this product.
FOR USE WITH THE FOLLOWING PRODUCTS: (
LOFT TWIN
6 Bar)
*Mounting parts supplied suitable for installation to masonry wall.
ENGLISH
