Kymeta mTenna Plus, Installation Manual

Page: 2 / 25

Table of contents
1 Introduction 1
2 Package contents 1
2.1 mTenna Plus packaging 1
2.2 mTenna Select packaging 1
3 Before you start
2
3.1 Prerequisites
2
3.1.1 Installation tools required for installation 2
3.1.2 Files required for installation 2
3.2 Check installation site requirements 3
3.2.1 Check electrical systems for safety 3
4 Installation 4
4.1 Install KyWay outdoor units (ODUs) 4
4.2 Label ODU components
4
4.3 Assemble KyWay indoor unit (IDU)
5
4.3.1 Install the rack unit 5
4.3.2 Connect the cables 6
5 Set up mTenna Plus modem side Ethernet 7
6 Adjust ASM software and IP address 8
6.1 Configure a descriptive name for each ASM (optional) 9
7 Power on the system 10
8 Configure expected number of ODUs
11
9 Verify cables
11
10 Verify self-test results 12
10.1 Power-on self-test 12
10.2 Built-in self-test 12
10.3 Verification 12
11 Set mTenna Plus reboot time 14
12 Transmit power calibration and commissioning 15
12.1 Verify OpenAMIP communication
15
12.2 Transmit power calibration
15
12.2.1 Set mTenna Select attenuation 15
12.2.2 Align BUC compression points 16
13 Revision history 18