© 2018 Kymeta Corporation and its affiliates.
4
25 October 2018
mTenna Plus and mTenna Select Installation Guide
4 Installation
4.1 Install KyWay outdoor units (ODUs)
Install each KyWay ODU according to
700-00019-000 KyWay Terminal Installation Guide
. If you are using the adapter
kit, before mounting each KyWay ODU, swap the voltage-switched LNB provided with the KyWay terminal with the
tone-switched and externally-referenced LNB NJR2842EN. Refer to
700-00032-000 KyWay Terminal User Manual
for
instructions on how to replace the LNB.
4.2 Label ODU components
To reduce the possibility of crossing cables, Kymeta recommends that you label all components of each KyWay ODU.
This recommendation includes labeling the ODU, IDU, and cabling from the ASM to its corresponding mTenna I/O.
The following table is a list of cables that you will need to label at both ends. Refer to the cabling diagram in
for a drawing of the cables described in the table below.
ODU
IDU
mTenna Plus
mTenna Select
ODU-to-mTenna Plus
RX cable
mTenna I/O-to-switch
Ethernet cable
mTenna Plus-to-modem
RX cable
mTenna Plus-to-modem
TX cable
ODU-to-mTenna Select
TX cable
mTenna I/O power cable
mTenna Plus-to-switch
Ethernet cable
mTenna Select-to-
mTenna Plus shielded
Ethernet cable
ODU interface cable to
mTenna I/O
Modem power cable
mTenna Plus-to-modem
Ethernet cable
Network switch power
cable
mTenna Plus power cable
