KWS VAROS109, Manual, Page: 38 / 78

36 Chapter 06 – Measuring range
10911 V01.10
Selecting
LNB
> Prog.ADo. opens a “Configurator” which can be used to analyse and program an antenna wall outlet
connected to the measuring device.
The figure below shows the measuring device in the antenna wall outlet configuration mode.
An X represents a locked user band (UB) bandpass slot and a green check mark indicates an unlocked UB slot. The
current configuration is displayed in the “act.” line. This configuration can be determined by selecting “
Config. read
” or
edited by selecting “ Config. write ”. The “n-1” line displays the last successfully programmed configuration, “n-2” dis-
plays the configuration previous to this, etc.
To change the current configuration, proceed as follows:
Select the “ Config. write ” menu using the up and down keys . Then press the > key to access the following menu.
The desired configuration can be set using the up and down keys as well as the
←
and
→
keys. Pressing
ENTER
programs this configuration and returns you to the original menu.
If the programming was successful, this configuration is shown in the lines “n-1” and “akt.”, the previous contents of
line “n-1” is now in line “n-2”, etc. If the programming was not successful, the message “
DiSEqC answer incorrect ”
appears briefly and the lines n-1 to n-3 remain unchanged (the configuration is transmitted using DiSEqC commands).