26 Chapter 06 – Measuring range
10911 V01.10
The 14/18 V - 22 kHz control follows immediately after a DiSEqC sequence. This allows non-DiSEqC-compatible compo-
nents to be run when DiSEqC control is active.
The image shows the selection menu for the DiSEqC versions and single-cable standards.
6.5.2.1 DiSEqC V1.0 control
When
LNB
> DiSEqC > V1.0 is set, the device operates according to DiSEqC Standard V1.0 and allows you to control up
to four satellite positions with up to four SAT IF levels each.
A SAT IF level is set using
LNB
> SAT-IF-Layer > V/Lo, H/Lo, V/Hi, H/Hi.
Set a satellite position using
LNB
> Satellite > P1—P4. P1 can be used for ASTRA and P2 for EUTELSAT, for example.
6.5.2.2 DiSEqC V1.1 control
LNB
> DiSEqC > V1.1 activates the DiSEqC V1.1 menu. V1.1 allows you to control a total of up to 256 SAT IF levels. V1.1
also allows for DiSEqC component cascading.
This means that compatible multiswitches or switching relays can be connected in series. Multiple repetitions of the
DiSEqC command(s) are required for this. See the following example for further information.
The SAT IF level settings and satellite position settings are identical to those for V1.0. Added to this is the control
“Uncommitted switches”, which is operated via
LNB
> Uncommitted Switch. With “Uncommitted switches” you can
split the 16 SAT IF levels that are possible with V1.0 into another 16 branches using the cascading option; this is
achieved using 4 additional switches (uncommitted switches). In total, up to 256 SAT IF levels can be controlled. The
“uncommitted switches” are binary controlled. The Up/Down arrow keys allow one of the 16 possible combinations of
Summary of Contents for VAROS109
Page 1: ...VAROS109 Digital satellite measuring receiver Manual ...
Page 2: ......