- 27 -
11. Checking and Maintenance
Warning: Electric Shock/Injuries
•
Before performing any equipment check or maintenance, stop the engine, and
remove engine key. A person performing the maintenance should always keep the
key.
Caution: Fire/Burns
•
Keep the equipment far away from fire.
•
When checking engine, always stop the engine, and keep away from fire.
•
Wait until the engine cools down, before performing any checks.
•
Do not open the side panel during operation and immediately after stopping the
equipment, because some parts/components (flexible tube, resistors, etc.) can
reach very high temperature inside the equipment.
<Note>
•
The authorized technicians should perform all checking and maintenance work,
except for the pre-startup checks.
•
Request for the maintenance item with
●
mark to the authorized distributor or
our engineering section.
•
Always use our genuine parts of replacement.
To optimize the use of this generator/welder, we recommend the periodical equipment
checks and maintenance based on the following matrix.
Use the hour meter as a guide for the operating time.
Checking Time
Checking Items
Startup
Check
50th
hour
Every 100
hours
Every 200
hours
Every 400
hours
Every
1,000
hours
Every
2,000
hours
1 Check and Supply Fuel
2
Check and Supply
Engine Oil
3 Engine Oil Change
1st time
2nd time
and after
4 Oil Filter Change
1st time
2nd time
and after
5
Check/Add
Water/Coolant
6 Water/Coolant Change
or
1
year
7 Clean Fuel Strainer
1st time
2nd time
and after
8 Change Fuel Filter
9
Drain Water/Clean Fuel
Tank
10
Check Leakage Fuel,
Oil, Water
11
Check/Add Battery
Water
12 Clean Air Element
1st time
2nd time
and after
Summary of Contents for dgw400dm
