kWiet Power dgw400dm, Owner'S And Operator'S Manual

Page: 22 / 40

- 19 -
<Note>
•
Do not drive the starter motor for more than 15 seconds successively.
•
If you need to restart, wait for 30 seconds or more before retry.
•
Once the engine has started, never turn the starter switch to START.
■
Restart after stopping due to fuel shortage
This equipment is incorporated in automatic vacuuming air feature. Therefore, even
though the engine stops due to running out of fuel, you can restart the engine easily
by the following steps.
1) Turn the starter switch to STOP.
2) Fill the fuel.
3) Turn the Slow-Down switch to ON.
4) Turn the starter switch to START and dive the starter motor for about 10
seconds.
5) Release the starter switch, as promptly as the engine started.
6) Wait for about 1 minute to vacuum the air out. The engine speed becomes
stable when the air is extracted.
<Note>
•
Never turn the engine NORMAL speed or connect the loads until the air is
extracted completely (the engine speed becomes stable).
7-2. Stopping
1) Turn (Push-down) the breakers (1-P and 3-P) to OFF.
2) Turn the Slow-Down switch to ON.
3) Keep the engine idle (cooling down) for about 5 minutes.
4) Turn the starter switch to STOP.
5) After the engine has stopped, turn the fuel lever to CLOSE.
<Note>
•
When the engine does not stop in spite of turning the starter switch to STOP, turn
the fuel lever to CLOSE, then the engine will stop in a few minutes.
In this case, be sure to consult with our authorized distributor or our engineering
section and ask to repair.
7-3. Emergency Stopping
The emergency stop feature is incorporated in the equipment.
Press the emergency stop switch in case of an emergency or equipment
abnormality during operation.
STARTER SWITCH
SLOW DOWN SWITCH
3-P BREAKER
1-P BREAKER