kWiet Power dgw400dm, Owner'S And Operator'S Manual

Page: 21 / 40

- 18 -
■
Replacing battery
1) Remove the clamp and cable from negative (-) post in the battery.
(Remove always negative side first)
2) Remove the hold-down clamp from the battery.
3) Remove the clamp and cable from positive (+) post in the battery.
4) Remove the battery from the seat.
* Reinstall a new battery in the reverse order. (Install always the cable to the
positive (+) post in the new battery first.)
<Note>
•
Use the following battery. 55B24L (Japanese Industrial Standard)
Warning: Suffocation from Exhaust Fume
•
Exhaust fume from the engine contains many elements harmful to human. Do not
operate this equipment in poorly ventilated area, such as inside a room or in a
tunnel.
Warning: Fire
•
Temperature around muffler and exhaust can get extremely high. Keep any
inflammable items (such as fuel, gas, paint, etc.) away from the equipment.
•
Always operate this equipment on flat surface and, at least 1 meter away from
any objects (wall, box, etc.).
Caution: Suffocation from Exhaust Fume
•
Do not point the exhaust fume toward pedestrians or building.
Caution: Injuries
•
Always place the equipment on a flat and stable surface, to keep the
equipment from sliding. Be sure to lock the wheels for the wheeled models.
•
Before starting the engine, be sure to disconnect the loads and set the breakers
(1-P and 3-P) to OFF position.
7-1. Starting
1) Turn the breakers (1-P and 3-P) to OFF position.
2) Turn the fuel lever to OPEN.
3) Turn the Slow-Down switch to ON.
4) Turn the emergency stop switch to release.
5) When the temperature is below -5
°
C
,
turn and keep the starter switch to
PREHEAT until the preheat lamp turns OFF (about 5 seconds)
6) Turn the starter switch to START and then the engine starts by the starter
motor.
7) Release the switch, as soon as the engine has started.
8) Keep the engine idle for about 5 minutes.
7. Operation