kWiet Power dgw400dm, Owner'S And Operator'S Manual

Page: 17 / 40

- 14 -
5-6. Single Phase Breaker for the receptacle circuit only
Caution: Electric Shock/Injuries
•
Be sure to disconnect all the loads to the generator when turning the breakers ON
again, after the 1-Phase Breaker has activated.
1) Disconnect all the loads.
2) Turn the breaker to ON.
<Note>
•
Do not exceed the maximum output. Refer to No. 9-2 Output Limitation.
•
The 1-P breaker protects the receptacle circuit only.
5-7. The Slow-Down Feature
The slow-down feature is to set the engine speed low automatically (in about 8
seconds) for the purpose of reducing noise and fuel consumption, whenever no
welding operation or electric supply is performed.
In the case of using the SLOW-DOWN feature, turn the slow-down switch to ON.
By the condition, the engine automatically moves to high speed, whenever welding
operation or electric supply starts.
Caution: Damage to the equipment or other properties
•
Turn always the slow-down switch to OFF, when the load is incorporated with any
magnet switch.
<Note>
•
When the load of less than 0.5A is connected to use, the Slow-Down feature does
not function sometimes. Therefore, turn the switch to OFF.
•
When welding operation or electric supply performs alternately or intermittently,
turn the switch to OFF.
•
When the output selector switch is positioned to Eco, the engine does not turn to
high speed.
5-8. Voltage Adjusting Dial
Adjust the dial whenever the AC Output adjustment is necessary. Set the dial in the
center usually.
<Note>
•
When raising the voltage, the current is decreasing. (Use the output within the
output capacity.)
•
In you raise the voltage exceeding the allowable voltage range, which causes the
damage to the loads.
DECREASE
INCREASE
VOLTAGE ADJ. DIAL