28
Connect Power to the System
NOTE:
When powering up a SWM configuration,
apply power to all other system components before
powering up the receivers and DVRs (tuners are
assigned SWM channels during startup).
Follow these steps to connect power to the
TracVision system (see Figure 45).
NOTE:
These instructions assume you will connect
the system to AC power using the supplied AC-DC
power adapter and AC power cable. Alternatively, you
can connect the system to a
24 VDC power source
using the supplied DC power cable (see Figure
45).
a.
Connect the 24 VDC AC-DC power adapter
(
supplied in kit
) to the “DC In” connector on
the rear panel of the TV-Hub.
b.
Connect the appropriate AC power cable
(
U.S. and E.U. cables supplied in kit
) to the other
end of the power supply.
c.
Connect the AC power cable plug to the
vessel’s 120 VAC or 240 VAC power source
(90-260 VAC 50/60 Hz).
d.
Check for proper grounding by using a
multimeter to measure the AC and DC
voltages between the ground stud on the rear
of the TV-Hub and ship’s ground. The
measured voltage should be less than
2 VAC and 2 VDC.
A higher voltage indicates
a dangerous floating ground condition.
e.
Repeat step
d
with the TV-Hub powered on,
looking for the same measured result.
WARNING
If you measure 2 volts or greater between the
ground stud on the rear of the TV-Hub and
ship’s ground, notify the ship’s electrician or
authorized vessel representative immediately.
This is a dangerous condition. Do not touch
the TV-Hub rear panel or connect anything to
it until the problem is fixed.
Figure 45: TracVision System Power
Wi-Fi
LEN=1
10-30V
POWER
MAX CURRENT 9.5A
NMEA 0183
B
A
FUSE
ETHERNET
DSWM
RECEIVER
GROUND
ANTENNA
RESET
NMEA 2000
DC IN
DC In
10A Fuse
Connecting to AC Power
Connecting to DC Power
Wi-Fi
LEN=1
10-30V
POWER
MAX CURRENT 9.5A
NMEA 0183
B
A
FUSE
ETHERNET
DSWM
RECEIVER
GROUND
ANTENNA
RESET
NMEA 2000
DC IN
10A Fuse
Ground
20
-30 VDC Power
DC Return
Ground
24 VDC AC-DC
Power Adapter
Note: Both U.S.
and E.U. AC power
cables are supplied
in the kit.
AC Power
Cable (U.S.)
AC Power
Cable (E.U.)
90-260 VAC
50/60 Hz Power
DC In
All power connections must be hard wired.
IMPORTANT!
Continued
Connect Power
13
Summary of Contents for TracVision TV10
Page 1: ...TracVision TV10 Installation Guide ...
Page 53: ......
