Kverneland Qualidisc Farmer, User Manual

Page: 46 / 71

Adjustments
46
Passive knife skids
Introduction
Use this configuration if:
•
You want a coarser level and surface finish in order to avoid any
risk of surface breakdown.
•
You are working in the autumn and you want to sow in the spring.
•
You are not planning to sow for a long time.
Adjustment procedure

on Actiring and Actipack
Raise the knife skids fully to put them in the “ OFF ” position (folded
away).

Loosen the locknut.

Loosen the countersunk screw A with the small wrench B so that it
protrudes by about 1 cm from its conical housing.

Loosen the locknut on the other side.

Engage the long wrench C on the welded nut located on the lower
part, so that the rear rail is supported.

While holding the wrench C in position, loosen the countersunk
screw A with the small wrench B so that it protrudes by about 1 cm
from its conical housing.

Swing the rail to the required position (“ 1 ”, ” 2 ”, “ 3 ” or “ OFF ”).

Still holding the wrench B in position, fully tighten the countersunk
head screw A .

Tighten the locknut.

Go to the other side to completely screw in the other countersunk
head screw
A . If necessary, use the wrench C again to adjust the
alignment of the screw in the desired position.

Tighten the second locknut.
Scrapers on Actipack
If using scrapers on the roller:

Set the scrapers to the “ OFF ” position.

The scraper must not touch the central tube, respect a clearance
of 5 mm (
3/16”
) to 10 mm (
6/16”
) from the tube.
A B C