SECTION 7—OPERATION
7.10
7.3.1 HOLD MODE – MOVING OPPOSITE
The Raptor RP-1 may be placed in the Hold mode (non-
transmit) by pressing selected antenna’s Hold switch on the
remote control (“FRNT HOLD” or “REAR HOLD” or
pressing the front panel Hold switch. “HOLD” will be
displayed in the message area and above the primary target
area. To return to normal radar operation, press one of the
Hold switches again.
7.3.2 MOVING MODE – TARGET LOCK
1. To lock the target speed reading, press the LOCK
switch on the remote control or the front panel. A short
alert tone will be heard, and the Locked target speed
will be displayed in the Lock area.
2. The Raptor RP-1 will continue to track the target and
patrol speeds.
3.
When the patrol vehicle’s speed has dropped 10 mph
(16 km/h) below the speed when lock was activated, or
the unit is placed in Hold, the patrol vehicle’s speed, at
the time of lock, will flash in the Patrol area. This
allows the operator to continue to track the target while
monitoring the patrol vehicle’s speed and still retain the
locked patrol speed. The operator may blank the locked
Patrol speed display by pressing the Test (
) switch.
Pressing the switch again will return the locked Patrol
speed display.
NOTE: While Locked the operator cannot change the
mode of operation, such as stationary to moving.
4. The locked speeds may be unlocked by:
A. Pressing the remote control or front panel Lock
switch again.
B. Auto-unlock after 14 minutes, if activated.
