SECTION 7—OPERATION
•
Receding only (REC ONLY) - rear antenna:
Receding targets behind the patrol vehicle are
displayed, approaching vehicles not displayed.
Stationary Setup:
1.
Place the unit in the desired stationary mode. Switch to
the desired antenna (Front / Rear). Set range and audio
to the desired level.
2.
*If desired, turn the microwave transmitter off by
pressing the remote control HOLD switch for the
selected antenna or by pressing the front panel Hold
switch. "HOLD" will be displayed in the message area
and above the Target area.
3.
Complete a tracking history on the target vehicle.
A.
Observe the target and surrounding traffic.
B.
Estimate the speed of the target vehicle.
C.
*Depress the HOLD switch to turn the microwave
transmitter on.
D.
Listen to the pitch of the audio; it should
correspond to the estimated speed.
E.
Observe the speed-reading shown in the Raptor
RP-1’s Target area display. It should correspond
with B and D above.
F.
Observe the indication of the target's direction of
travel from the road graphics indicator. It should
correspond to the observed target's direction of
travel.
7.5
