SECTION 6—TESTING PROCEDURES
6.10
6.6 MINIMUM PATROL SPEED SET
When the speedometer input feature is not used, the Raptor
RP-1 allows the operator to set a minimum patrol speed of
10, 20, 30 or 40 mph (16, 32, 48 or 64 km/h).
To activate this feature:
1.
Press the Menu (
) switch to go to the main menu
screen.
2.
Use the Up / Down switches to highlight the PAT
MIN selection and press ENTER. The current
Patrol minimum setting will be blinking.
3.
Use the Up / Down switches to change the patrol
minimum setting to 10, 20, 30, or 40 mph. Press
ENTER to save the new setting. Press ENTER
again to exit the menu screen.
NOTE: The lowest value (10 mph/16 km/h) is the default
setting. At this setting the typical patrol speed
readings will be 6 mph / 10 km/h.
6.7 MOVING MODE TEST
Verification of speed readings between the patrol vehicle's
speedometer and the Raptor RP-1’s PATROL speed
display is another accuracy test that can be performed.
These readings should be the same, or within reasonable
limits, allowing for minor speedometer error.
Speedometer checks should be done on a daily basis. If a
discrepancy is found, the radar unit should be removed
from service until the error can be corrected.
