Programming Your PC2R
Basic Editing Concepts
4-3
Naming and Storing
Storing (saving) is optional, of course. If you don’t want to store any of your changes, press
Cancel
one or more times to return to the mode you were in before you started editing.
Although naming is obviously optional as well, we’ll assume you’re going to name the object
you’re editing before storing it.
This procedure describes storing a setup, so it assumes that you’re in MIDI Setups mode. The
process is similar for naming and storing other objects.
1. Press
Store
(in the Functions group of buttons). The display will show either
Save|Setup|NNN?
or
Replace|Setup|NNN?
where
NNN
is the setup ID.
•
If you’re in the Internal bank of setups, the display will show
Save|setup|NNN?
where
NNN
is the first available setup ID in the User bank of setups.
•
If you’re in the User bank, the display will show
Replace|setup|NNN?
where
NNN
is the ID of the current setup. Use the Alpha Wheel to change the ID if you want to
save a new setup instead of replacing the current one.
2. Press the
Right
cursor button to display
Rename|setup|NNN?
3. Press
Yes
(
Enter
). The display shows the name of the current setup, if any. The cursor
highlights the character that’s selected for editing.
4. Use the Alpha Wheel to change the character highlighted by the cursor. Use the cursor
buttons to move the cursor.
5. When the name looks the way you want it, press
Yes
. The display again shows either
Save|Setup|NNN?
or
Replace|Setup|NNN?
, depending on where you were when
you started storing.
6. Press
Yes
(or press
No
if you don’t want to store the setup after all). The display briefly
shows
Setup|NNN|saved!
then returns to MIDI Setups mode.
Special Characters For Naming Objects
Here are all the characters available for object names, in the order in which they appear:
! " # $ % & ' ( ) * + , - . / 0 1 2 3 4 5 6 7 8 9
: ; < = > ? @ A through Z
[ \ ] ^ _ ’ a through z (space)
When you’re naming objects, you can press
Zone 1
to switch a letter from upper to lower case,
or vice versa. Press
Zone 2
to insert a space at the cursor, moving the remaining characters to the
right. Press
Zone 3
to delete the character at the cursor, moving the remaining characters to the
left. Press
Zone 4
to move the cursor to the end of the name.