- 32 -
4. BELTS
Belts must be properly tensioned at all times to avoid
excessive flopping and slipping. Loose belts will also
cause poor cutting and premature wear.
Tension the belts by tightening the bolt (H) with the
18 mm box spanner (O) delivered with the machine
(photo 45).
For the correct V - belt tension, tighten the bolt until the
spacer tube (J) is in contact with the main frame plate
(E) and the washer (R).
During the initial assembly and when fitting new V-
belts, it is necessary to give 2 additional complete
turns of the bolt (H) in order to obtain the correct
tension.
Regularly check the tension of the V-belts, particularly
during the first hours of use.
Note : Belts must never be changed individually. If one of them becomes damaged, the whole set must be replaced
:
- code no 831 017 91 for GMD 600 GII / 600 GII-HD - 700 GII / 700 GII-HD
- code no 831 017 92 for GMD 800 GII / 800 GII-HD.
REGULARLY CHECK ALL NUTS AND BOLTS FOR CORRECT TIGHTNESS,
PARTICULARLY THOSE SECURING THE DISCS AND KNIVES.
Make sure cone lids (J) are properly secured in place (photos 43 and 44). Replace immediately a loosen or damaged
cone lid.
4 5
4 3
4 4
Summary of Contents for GMD 600 G II
Page 11: ...9 2 3 4 5 6...
Page 12: ...10 8 7...
