- 13 -
- Tension the V-belts (G) (photo 3) by tightening the
bolt (H) with the 18 mm box spanner (O), delivered
with the machine (photo 3 A).
- For the correct V-belt tension, tighten the bolt (H)
until the spacer tube (J) is in contact with the main
frame plate (E) and the washer (R), then tighten the
bolt with 2 additional complete turns.
Note : The 2 turns of the bolt necessary to obtain a
correct tension, only apply to new sets of belts
to compensate for the initial stretch new belts
are subject to during the first couple of hours of
use.
- Attach outer belt shield (X) with 3 washers and 3 cap
nuts (
I
) (photo 4). Torque : 5 daNm / 40 ft.lbs
- Assemble closing plate and outer belt shield with
one self-locking screw (K) (M 8 x 16) (photo 4).
On GMD 800
GII /
800
GII
-HD, assemble the inner
closing plate and the outer belt shield with one self-
locking screw (K) (M 8 x 12) (photo 4A).
4. Installing the frame pipe
- After cleaning attach frame pipe (L) (photo 5) to bevel
gearbox with 4 screws (M) (M 16 x 40). (Torque : 21
daNm / 155 ft.lbs).
3 B
4
4A
5
Summary of Contents for GMD 600 G II
Page 11: ...9 2 3 4 5 6...
Page 12: ...10 8 7...
