- 12 -
2. Mounting chassis to cutterbar
Make sure that the bore of nylon bushings is clean and well greased. Remove protective paint from the front cover
of bevel gearbox where bushings make contact.
Attach the frame to the cutterbar using 2 self locking screws (B) (M 16 x 50) and 2 washers (A) (diameter 16,5 x
60) as shown in photo 2 and fig.2. Torque : 30 daNm / 220 ft.lbs.
Install the compensating spring rod (N) to the pin (C) using roll pin (E) (diameter 8 x 50) (photo 2).
3. Assembly of belt shield and belts
- Install the inner belt shield (D) (photo 3) in place and
secure with the 3 spacer bolts (E) taped on the stop
chain. Torque to 5 daNm / 40 ft.lbs.
- Install closing plate (F) equipped with elastic nut as
shown in photo 3.
On GMD 800
GII /
800
GII
-HD, mount the inner
closing plate (M) using an elastic nut and a self-
locking screw (N) (M 8 x 12) (photo 3A).
- Install the V-belts (G) onto the pulleys (photos 3 and
3A).
- Place tensioning spring (K) inside spacer tube (J)
and install both parts over guide (L) (fig. 3).
- Slide special washer (R) onto bolt (H) and install this
bolt into guide (L) as shown in figure 3 and photo 3
A.
2
Fig. 2
3
3A
Fig. 3
Summary of Contents for GMD 600 G II
Page 11: ...9 2 3 4 5 6...
Page 12: ...10 8 7...
