KUHN GF 5001 MH, Assembly And Operators Manual

Page: 28 / 36

- 26 -
3) SIGNALLING ELEMENTS (Kit No. 111 6680)
To install the warning board / light kit, proceed as follows :
- Remove rear cosmetic shield (V) and reflector supports (1) (Foto 5, page 13).
- Install warning board supports (3) (fig. 31) in place of reflector supports using the original fixation hardware,
then reinstall cosmetic shield (V).
- Next attach extensions (2) on supports (3) using 4 hexagon screws (16) (M 10 x 30) and 4 self-locking nuts (5)
(M 10) (fig. 31).
- Then bolt bar (1) to extensions (2) with 4 hexagon screws (16) (M 10 x 30) and 4 self-locking nuts (5) (M 10) (fig.
31).
- Press plugs (9) into each end of the bar (1) (fig. 31),
- Bolt warning boards (12) onto bar (1) with 6 hexagon bolts (13) (M 10 x 45) and 6 self-locking nuts (14) (M 10),
making sure that the red and white stripes are facing in the right direction (fig. 31). On machines marketed in
Switzerland, the 4 yellow and black stickers supplied with the set must be affixed to the signal panels (12) in place
of the red and white stickers.
- Fit front lights (A) on the front side of the warning boards (12) (slit E is facing down) (photo 32).
- Fit right rear light (D) marked "R" onto the rear side of the right warning boards (photo 33).
- Fit left rear light marked "L" onto the rear side of the left warning board. This rear left light is also marked in white.
- Then attach the electric harness to extensions (2) with 4 clamp collars (C) (length 176 mm) and to the central spacer
tubes (15) with 2 clamp collars (F) (length 350 mm) as shown in photos 32 and 34. Plug the harness connectors
into the corresponding front and rear light connectors.
Note : The electric cables for the rear lights are marked "L" for left and "R" for right. The electric cable for the rear
left light is also marked in white.