KUHN GF 5001 MH, Assembly And Operators Manual

Page: 15 / 36

- 13 -
5) Fitting the wheels (photo 4)
Fit the pre-assembled wheels (G) into their holders (F).
Place a shim washer (
I
) (dia. 35 x 45 x 2.5) on top of the
holder. Then install shim washer (K) (dia. 35 x 50 x 1).
Secure in place with retaining ring (H). To complete the
job install protective caps (J).
4
3A
3
3) Fitting the 3-point frame (fig. 3)
Attach the 3-point frame (C) to the connecting frame
(P) by means of the vertical pivot pin (A) and secure
in place with roll pins (E) (5 x 50 mm) and (E’)
(8 x 50 mm) as shown in figure 3.
Attach the pendulum arm (B) to the 3-point frame (C)
by means of the horizontal pivot pin (F).Secure the
horizontal pin (F) with roll pins (G) (8 x 50 mm). The
roller (H ) must locate in housing
(I)
.
Slide cover (Y) in place on triangular plate (
I
) of
connecting frame (P) with 2 hexagonal screws (M10x25)
and 2 self-locking (M10) (drawing 3 and photo 3A).
4) Fitting the stand (photo 3A)
Slide parking stand (M) in housing (N) and fit roll pin (X)
(dia. 8 x 55). Lock the parking stand in the lowered
position with R-clip (O) and install PVC cord (Q) as
shown in photo 3A.