KUHN GF 5001 MH, Assembly And Operators Manual

Page: 14 / 36

- 12 -
ASSEMBLY INSTRUCTIONS
2) Fitting the connecting frame (photos 2,
2A and 2B)
Assemble connecting frame (P) to crossbar (T) using the
following hardware:
- 4 bolts (D) (M12x100) and self-locking nut M12
- 1 bolt (D’) (M12x110), plain washer (12.5x25x1.5) and
self-locking nut M12.
Also assemble the connecting frame (P) to central gearbox
(J) using 6 self-locking screws (K) (M12x35) (photo 2A).
Tighten all this hardware to 10 daNm / 75ft.lbs
Note : Make sure to place hydraulic hose holder (L)
between the connecting frame underside and the
self-locking nut M12 when fitting bolt (D’) (photo 2).
Connect hoses (R and S) to the hydraulic T-union (U) and
to hydraulic cylinders (V) as shown on photos 2, 2A and
2B.
2B 2A
2
1
1) Fitting of the outer wings and cylinders
(photo 1)
Make sure not to invert left and right wings. Grease
Digidrive coupling fingers.
Connect cylinder barrels (V) to axles (A) using roll pins (C)
(8x40) and plain washers (B) (21x33x4). Insert hinges (M)
in housings (N) respecting the rotor timing thanks to O-
rings (Q) placed on the Digidrive coupling fingers.
Install pivots (E) using roll pins (F) (8x50 and 5x50). Make
sure to fit pivots equipped with an angled grease zerk at the
rear of the machine.
Insert the flexible guard strips (G) underneath brackets (H).