6. - Putting into service
EL162
47
KN146AGB_L
Cultiplow
6.1.5 Primary PTO shaft
The direction of rotation is shown on a decal.
- Separate the two half PTO shafts and connect
them to the machine's input shaft and to the tractor
PTO stub.
- Check the length of the PTO shaft:
• When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against
the yokes. There must still be a minimum safety
travel (L) of 25 mm (1’’).
•
When extended to the maximum, the tube
overlap must not be below 250 mm (10’’).
If this is not the case:
Never operate the PTO shaft at an angle X
exceeding 30°.
Before using the machine for the first time:
- Grease the transmission.
- Check overlap of the u-joint drive shaft and
adjust length if necessary to avoid any
premature wear.
- Follow instructions given in the operator's
manual delivered with the PTO.
H
L
X
X
Summary of Contents for EL162
Page 2: ......
