KUHL Quantron E2, Original Instructions Manual

Page: 61 / 108

Operation of the Quantron E2
55
4
The number of pulses of the speed signal must still be specified below. If you
know the exact number of pulses, you can enter it directly:
7. Highlight the Imp/100m submenu and press the enter key .
The pulses menu is displayed for manual input of the number of pulses.
Entering values into the control unit is described in section 4.11.2: Input of values
using the cursor keys, page 89 .
If you do not know the exact number of pulses, you can start the calibration run .
8. Press the function key F4 (Auto) .
The calibration run operating screen is shown in the display.
Figure 4.31: Calibration run speed signal operating screen
[1] Pulse display
[2] Stop recording pulses
[3] Start recording pulses
9. At the starting point of the reference distance, press the function key F1 .
The pulse display is set to zero.
The control unit is ready for counting pulses.
10. Drive the 100 m reference distance. Stop the tractor at the end of the refer-
ence distance.
11. Press the function key F4 .
The display shows the number of received pulses.
12. Press the enter key .
The new pulse count is saved. This returns you to the calibration menu.
13. Press the ESC key to return to the previous menu
or
press the menu key to return to the operating screen .
1
2
3