Service and maintenance
111
9
9.11
Manual adjustment of the drop point
Deactivating the actuator control
The actuators which are electrically operated for the drop point adjustment must
be disconnected prior to manual adjustment of the drop point.
NOTICE
If the drop point can no longer be electrically actuated it is adjusted manually.
1.
Disconnect the adjusting rod
from the adjustment centre
on both sides
. Remove the
pins to do this.
Figure 9.32:
Removing a pin
2.
Push rod to the side.
3.
Put pins back into the yoke
and lock.
Figure 9.33:
Remove rod
Summary of Contents for AXIS H 30.1 EMC
