Maintenance
1.
Oil changer
7.
If the oil changer is not available, remove
the drain screw while holding a container under
the drain hole. Let the oil drain completely. Wipe
up any spilled oil immediately.
10.
Install the oil filler cap and tighten it
completely.
11.
Leave the outboard motor for 5-10
minutes.
12.
Remove the oil filler cap and wipe the
attached oil dipstick clean.
13.
Install the oil filler cap and tighten it
completely.
14.
Remove the oil filler cap again and
check that the oil level on the dipstick is
between the upper and lower marks. If the
oil level is not at the proper level, add or
extract oil until the oil is between the
upper and lower marks.
15A. Start the engine and make sure that
there are no oil leaks.
NOTICE:
If there are
oil leaks, stop the engine and find the
cause.
1.
Drain screw
2.
Washer
8. If the drain screw was removed, install a new
washer and drain screw, and then tighten the drain
screen.
Engine oil drain bolt:
18.0 Nm (1.84 kgf-m, 13.3 ft-lb)
9. Add the correct amount of oil through the filler
hole.
NOTICE:
Overfilling the oil tank could
cause leakage or damage. If the oil level is
above the upper mark, extract oil until the oil
is between the upper and lower marks.
.
56
4-stroke outboard motor oil
Engine oil quantity:
20 ounces
Summary of Contents for MOTOR6
