Kuda MOTOR6, Instruction Manual

Page: 21 / 82

21
Components
1. Fuel joint cap
Manual starter handle
Used to crank and start the engine.
1. Steering friction adjuster
To increase resistance, turn the steering
friction adjuster clockwise.
To decrease resistance, turn the steering
friction adjuster counterclockwise.
Trim rod (tilt pin)
The trim rod (tilt pin) is used to adjust the trim
angle of the outboard motor in relation to the
angle of the boat transom.
1. Manual starter handle
Steering friction adjuster
WARNING
Do not overtighten the steering friction
adjuster. If there is too much resistance,
it could be difficult to steer, which could
result in an accident.
The steering friction adjuster provides adjust-
able resistance to the steering mechanism,
and can be set according to operator prefer-
ence. The steering friction adjuster is located
on the port side of the outboard motor.
1. Trim rod
Tilt lock mechanism
The tilt lock mechanism is used to prevent the
outboard motor from lifting out of the water
when the gear shift lever is in the
reverse position.
When the gear shift lever is moved to the
reverse position, the tilt lock mechanism
operates to prevent the outboard motor from
being tilted up.
1
1
1
1