MG-9
M9000DT-M, WSM
G GENERAL
(B) Adjustment Front Wheel Turning Stopper Bolt
Take the following steps to adjust the turning angle with the
stopper.
1. Slightly tighten the stopper bolt.
2. Start the engine. Turn the steering wheel to the right and left to
get the stopper two or three times into contact with the bevel gear
case. (This is to position the stopper’s contact face.)
3. Then hold the stopper with an adjustable wrench to prevent it
from getting out of position. Finally tighten the stopper bolt to the
specified torque.
IMPORTANT
■
• The turning angle varies depending on the presence or
absence of the front weight bumper as well as the tire size.
Adjust the stopper bolt with these factors in mind.
• Make sure that stopper bolts are always tightened to the
correct torque.
W1020179
(1) Stopper Bolt
A : Front
Stopper bolts adjustment (ex. LH stopper bolt)
Tread
2025 mm (79.7 in.)
2015 mm (79.5 in.)
1925 mm (75.8 in.)
1830 mm (72 in.)
1910 mm (75.4 in.)
Stopper
Tread
1665 mm (65.6 iin.)
1655 mm (65.3 in.)
1565 mm (61.6 in.)
1550 mm (61.1 in.)
Stopper
L
1
: 12 mm (0.47 in.)
L
2
: 3 mm (0.19 in.)
B : Stopper Bolt
KiSC issued 04, 2006 A
