M3-S4
M9000DT-M, WSM
TRANSMISSION
Wire Harness R.H. and Fuel Pipes
1. Disconnect the 3P connector for solenoid valve (3).
2. Disconnect the wiring lead (2) from the glow plug.
3. Disconnect the coolant thermo sensor 1P connector (1).
4. Remove the fuel pipes.
W1011919
Wire Harness L.H.
1. Disconnect the alternator 2P connector (1) and B terminal (2).
2. Disconnect the starter motor C terminal (5) and B terminal (4).
3. Disconnect the engine oil pressure switch terminal (3).
(When reassembling)
W1012136
Propeller Shaft
1. Slide the propeller shaft cover (3), (4) after removing the screws
(7), (8).
2. Tap out the spring pin (2), (6) and then slide the coupling (1), (9)
to the front and rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (5) and pinion
shaft.
W1012314
Gear Case
1. Remove the gear case mounting screw.
2. Remove the gear case assembly.
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to joint face
of the clutch housing and gear case.
W1012458
(1) Coolant Thermo Sensor 1P
Connector
(2) Wiring Lead for Glow Plug
(3) 3P Connector for Solenoid Valve
(4) Fuel Pipes
Tightening torque
Starter’s terminal B
mounting nut
8.8 to 11.8 N·m
0.9 to 1.2 kgf·m
6.5 to 8.7 ft-lbs
(1) Alternator 2P Connector
(2) Alternator B terminal
(3) Engine Oil Pressure Switch Terminal
(4) Starter Motor B Terminal
(5) Starter Motor C Terminal
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft Cover
(4) Propeller Shaft Cover
(5) Propeller Shaft
(6) Spring Pin
(7) Screw
(8) Screw
(9) Coupling
Tightening torque
Gear case mounting screw
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
KiSC issued 04, 2006 A
