KSI SC Pro, Owner'S/Operator'S Manual

Page: 11 / 49

7
KSi SC PRO APPLICATOR
USER'S MANUAL
15. NEVER attempt to assist machinery operation or to remove trash from the equipment while in
operation.
16. NEVER drive, stand, or walk under the equipment.
17. Use ample overhead lighting during periods of low light, such as after sunset, to light the work area.
18. Keep the area around intake free of obstacles such as electrical cords, blocks, etc. that might trip
workers.
Emergency Shutdown Sequence
See Emergency Shutdown on page 15 under the Operation section.
Pinch Points
A pinch point is any place on the equipment which can injure the operator.
1. Components of this equipment have sharp edges which can scrape and/or cut an operator.
2. A moving applicator can sever an operator’s limb or even kill.
Shields and Guards
1. Always keep all shields and guards in place during operation.
2. Missing shields for guards can be replaced for free by contacting KSi.
Beware of Electrical Hazards
Electricity can kill! Use extreme caution around electrical components.
Have your electric company check the transformer and lead wires to be sure they are large
enough to handle the additional load of the motor.
Electrical wiring should be done by a qualified electrician and all components shall comply with applicable
provisions of National Fire Protection Association Standard NFPA No. 70, American National Standard
Inst. ANSI-C1 or with the requirements of the authority having local jurisdiction. KSi assumes no
responsibility for the electrical wiring used with this machine.
KSi will not be liable for failure of the equipment due to poor or improper electrical power installation.
Wires which are too small deliver insufficient voltage causing the motor to overload or burn out.