KSB Deep Lift System, Installation & Operating Manual

Page: 10 / 34

3 Transport/Storage/Disposal
10 of 34
Deep Lift System
2553.89/04-EN
Table 4: Ambient conditions for storage
Ambient condition Value
Relative humidity Max. 85 % (non-condensing)
Ambient temperature -20 °C to +80 °C -4 °F to +176 °F
▪ Store the lifting accessory in dry, vibration-free conditions, and protect it against
the weather as far as possible.
▪ Store the lifting accessory in a dry room where the atmospheric humidity is as
constant as possible.
▪ Prevent excessive fluctuations in atmospheric humidity (see table Ambient
conditions for storage).
If stored properly, the product will be protected for a maximum of 12 months.
Preservation Preservation will protect the lifting accessory against corrosion if it is stored or shut
down for a prolonged period of time.
WARNING
Fluids, consumables and supplies posing a health hazard
Hazard to persons and the environment!
▷ Collect and dispose of any preservatives, flushing liquids and fluid residues.
▷
Wear safety clothing and a protective mask, if required.
▷ Observe all legal regulations on the disposal of fluids posing a health hazard.
NOTE
Observe the manufacturer's instructions for application/removal of the preservative.
1. Thoroughly clean the lifting accessory.
2. Evenly apply the preservative.
Removing the preservative Preservatives must be removed from the lifting accessory prior to commissioning.
WARNING
Fluids, consumables and supplies posing a health hazard
Hazard to persons and the environment!
▷ Collect and dispose of any preservatives, flushing liquids and fluid residues.
▷
Wear safety clothing and a protective mask, if required.
▷ Observe all legal regulations on the disposal of fluids posing a health hazard.
NOTE
Observe the manufacturer's instructions for application/removal of the preservative.
3.4 Return to supplier
1. Prior to returning the product to the supplier, flush and clean it, particularly if it
has been used in noxious, explosive, hot or other hazardous fluids.
2. If the product has been used in fluids whose residues could lead to corrosion
damage in the presence of atmospheric humidity or could ignite upon contact
with oxygen, the product must also be neutralised and treated with anhydrous
inert gas to ensure drying.
3. Always complete and enclose a certificate of decontamination when returning
the product. (
ð
Section 10, Page 30)
Indicate any safety measures and decontamination measures taken.