5 Installation at Site
25 of 36
AmaRoc
5.5.7 Fitting the submersible mixer to the submersible mixer stand
ü
The lifting bail has been fitted on the submersible mixer.
ü
Center of gravity position has been ensured.
1.
Suspend the submersible mixer from the lifting gear and position it over the
square guide rail.
2.
Lower the submersible mixer onto the square guide rail.
The pyramid-shaped insert sleeve at the top end of the square guide rail (on
free-standing models only) facilitates guiding the submersible mixer onto the
square guide rail.
3.
Lower the submersible mixer down into the tank along the square guide rail,
until the flexible rubber base of the motor housing bottoms in the bowl-shaped
mixer bracket.
Prior to that, the plastic plates of the guide bracket touch down on the top
edge of the mixer bracket and the unit tilts into the horizontal installation
position.
At this point, you will notice that the rope slackens a little.
4.
If a lifting hook is used, lower the rope a little bit further until the lifting hook
comes off the lifting bail (571) and the rope can be pulled in.
NOTE
To make it easier to locate the position of the submersible mixer at a later point,
the rope should be marked at the railing level.
