5 Installation at Site
26 of 36
AmaRoc
5.5.8 Fastening and tensioning the power cable
DANGER
Power cable not properly routed
Risk of personal injury! Risk of falling!
▷
Route the power cable in such a way that it cannot pull down any persons if the
pump set falls down or is lowered down.
CAUTION
Power cable routed with too much slack
Damage to power cable by propeller blades!
▷
Pull the cable taut before fastening it at the tank edge.
2
1
Fig. 11:
Fastening and tensioning the power cable
1
Carabine hook
2
Cable support
If possible, the power cable should be fastened to the tank edge at a distance of
approx. 31
1
/
2
" [0.8 m] from the side of the guide rail to prevent chafing on the guide
rail, which would damage the power cable.
1.
Fit the cable support to the power cable at the tank edge and use a carabine
hook to attach it to an appropriate point (e.g. railing or eyebolt).
2.
Pull the cable taut before tightening the cable support bolts.
Prevent chafing of the power cable (use appropriate pads at the tank edge, if
necessary).
5.5.9 Fastening the lifting rope
CAUTION
Slack lifting ropes
Damage to lifting ropes by propeller blades!
▷
When using a stationary crane mounted at the mixer's installation position,
ensure that the rope is routed up to the winch with a minimum of slack during
mixer operation.
