5 Installation at Site
24 of 36
AmaRoc
4.
Re-tighten all bolts.
5.
Repeat attachment procedure.
ð
If the angle of inclination is approx. 5°, the correct center of gravity position has
been found.
5.5.4 Lifting hook
NOTE
Lifting hooks can only be used in low-viscosity substrates.
9
3
/
1
6
“
[
2
5
0
m
m
]
Ø 1
9
/
16
“ [40 mm]
Fig. 9:
Lifting hook
The lifting hook has a maximum load-carrying capacity of 1100 lbs [500 kg].
For lifting/lowering with a lifting hook, the lifting hook is attached to the lifting rope
of the lifting equipment (crane) with a shackle.
5.5.5 Lifting rope
For lifting/lowering with lifting equipment, the lifting rope can also be attached
directly at the attachment point. It can remain attached during operation.
5.5.6 Fitting the protective cable sheath on the submersible mixer
Fig. 10:
Fitting the protective cable sheath
1.
To protect the power cable, slip protective cable sheath 719 over the cable end,
and slide it all the way up against the bushing.
2.
Fasten the protective cable sheath to bail 571 with cable ties 81-7.
