Settings
214
Pos: 32.109.16 /BA/Einstellungen/Großpackenpresse/Variables Füllsystem VFS/Anschlag der Tastschwinge prüfen HS Baureihe @ 63\mod_1299826779699_78.doc @ 576428
Fig.155
Checking the stopper (10).
After the VF system has been triggered the displacement 'E' between the stopper (10) (LHS of
machine) and the swivelled feeler rocker (1) must be checked.
When the feeler rocker (1) is deployed the displacement 'E' must lie between 3 - 8 mm.
If this is not the case, the stopper (10) must be adjusted while the feeler rocker is swivelled out.
To do this:
•
Loosen the screws (11).
•
Slide stopper (10) until the displacement 'E' lies between 3 – 8 mm.
•
Tighten the screws (11).
Pos: 32.109.17 /BA/Einstellungen/Großpackenpresse/Variables Füllsystem VFS/Dämpungseinrichtung HS Baureihe @ 63\mod_1299737271967_78.doc @ 575232
10.11.3 Absorbing
Mechanism
Fig.156
The purpose of the absorbing mechanism is to prevent the feeler rocker from triggering the VFS
clutch unintentionally by recoiling back against it.
The length of the braking path in the two stop positions can be adjusted with the slotted brake
jaw (2). Adjust the slotted brake jaw (2) so that the distance from the brake plate (3) in the
respective end settings of the feeler rocker to the two outer edges of the anvil (4) is the same.
Otherwise the slotted brake jaw (2) could restrict the rotating path of the feeler rocker.
The spring (1) on the brake should be pre-tensioned to a dimension of B = 50 mm (spring
length only).
Pos: 32.109.18 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
Summary of Contents for Big Pack 1270 HS
Page 12: ...Foreword 12 Pos 7 BA Seitenumbruch 0 mod_1196175311226_0 doc 4165 ...
Page 323: ......
