Settings
198
Pos: 32.100 /BA/Einstellungen/Großpackenpresse/Knoter/Inbetriebnahme Knoter @ 24\mod_1241083585365_78.doc @ 242950
10.8.2 Start-up
The knotter has been set and tested by the manufacturer. It should work properly without
requiring any further settings. If there are problems with tying when it is placed in service for the
first time, the mechanisms should not be set immediately, since this is usually caused by errors
that are caused by paint, rust and bare spots. It is recommended to remove the rust protection
grease from the twine retainer and knotter before start-up.
Pos: 32.101.1 /Überschriften/Überschriften 3/A-E/Einfachknoter @ 24\mod_1241083809568_78.doc @ 242978
10.8.3
Single knotter
Pos: 32.101.2 /BA/Einstellungen/Großpackenpresse/Knoter/Einfachknoter Raspe/Knüpferhaken Einfachknoter Raspe Bild @ 47\mod_1285048585953_78.doc @ 455461
10.8.4
Knotter hook (single knotter)
Fig. 136
Pos: 32.101.3 /BA/Einstellungen/Großpackenpresse/Knoter/Knüpferhaken Text Doppelknoter / Einfachknoter Raspe @ 47\mod_1285046930718_78.doc @ 455408
The knotter tongue (5) of the knotter hook (2) is tensioned by the leaf spring (3) on the closer
(1).
•
If the clamping effect on the knotter tongue (5) is too big, the knot will be left
hanging in the knotter tongue. The twine strand will rip
•
If the clamping effect is too low, either no knot or a loose knot will form. These
faults can be avoided by correcting the spring tension on the leaf spring (3)
To do this:
•
Undo nut (4) on the leaf spring (3) by about 60° or remove
Note
The knotter tongue (5) needs a slight minimum tension, for this reason never undo completely.
Pos: 32.101.4 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
Summary of Contents for Big Pack 1270 HS
Page 12: ...Foreword 12 Pos 7 BA Seitenumbruch 0 mod_1196175311226_0 doc 4165 ...
Page 323: ......
